The nanotechnology product Nano Degreaser & Polisher penetrates deep into the pores of various surfaces and it is able to remove a wide range of greases that could affect the adhesion and functionality of protective polishes. It is therefore used as a final degreaser before the protective polishes application.
The product is also an essential aid for final polishing of the protection polishes on glass (Nano Protect Glass), on glass-ceramic (Nano Protect Glass-Ceramic) and on stainless steel (Nano Protect Stainless). The product dilutes an uncured excess layer of protective varnish, which can then be easily polished. The total area for which the product is sufficient is 30 m2.
Package contents: 50 ml
Instructions for use:
Shake the product thoroughly before use.
The product penetrates deep into the pores of surfaces,
where it removes grease and dirt.
Surfaces degreasing before application of protections:
Even apparently clean surfaces hide impurities that can limit the functionality of the subsequent protection. It is therefore necessary to remove this dirt nad grease before applying the protection layer itself. The procedure is always the same, whether it is glass, lacquered surfaces, plastics, wood, textiles, or any other surface. On a clean, preferably microfiber cloth, lightly spray Nano Degreaser & Polisher and wipe the surfaces previously cleaned from coarse dirt. When treating smooth or shiny surfaces, always check if there are not any smudges left after degreasing. If everything is in order and clean, start applying protective polishes. If there are still some stains left on the surface, repeat the procedure until complete cleaning / degreasing.
Applying and polishing of protective polishes on glass, glass-ceramics and stainless steel:
Because some types of surfaces have a complex structure and they are exposed to extreme conditions, we have adjusted the compositions of the individual protection products accordingly. Due to the hardness of some of them, polishing done the usual way is very difficult. We have therefore modified Nano Degreaser & Polisher the way it dilutes excess protective layer so it is easy to remove / polish it from the surfaces. To do this, we use a microfiber cloth, on which we lightly spray the degreaser and immediately start polishing. Do not put too much pressure on the cloth - in the case more effort starts to be needed, add another little amount of the product on the cloth and continue working. The cloth absorbs excess polish, so it is advisable to keep folding it and turn it at the time when it starts to leave a smudges on the polished surface. Similarly, the product can be used for polishing other protecting polishes, which are standardly polished only with a dry microfiber cloth. If you have applied too thick layer the polishing may became more difficult. In this case, the Degreaser and Polisher can also be used to polish and restore such affected areas.
Always apply the degreaser on the pre-washed / pre-cleaned surface, free of coarse dirt, so that you avoid scratching the treated surface.
The product must not be confused with CAR range products! Due to the different composition, the protective layer could be damaged and the protections might not work.
Types of hazards: Flammable liquid, irritating to eyes with possible toxicity to specific target body organs.